arriving calls become at the MFC-885CW after 2sec. interrupted by the FAX

Nextiva is a cloud based VoIP phone system, hosting lots of small and medium sized businesses nationwide. the provides UNLIMITED business calling for only $19.95 a month!! Click here for the detail about this promotion!!

A very strange problem (hardware lead I following) has:
Use FRITZ! Call numbers lay box hair dryer WLAN 7113 at a 1und1 complete connection with 2. At the first number (telephone connection) everything functions perfectly. But at the combination fax connection to bread ago mfc a 885cw hangs, breaks to me a eigehendes discussion after 2 seconds. away and the fax sends receipt tones to the Arufer. (Caller calls also over 1und1 VOIP) property then times by a mobile telephone the number of the COMBINATION EQUIPMENT called and see there, there the discussion by the FAX of the MFCs one does not interrupt. Property also of an old similar T-COM connection times to call leave -> functions also!!!

Why rise BREAD AGO to fax receipt over if does the enter-entering that call from the Internet is received? Both connections are as TELEPHONE in the BOX configure. (I cannot select fax or combination). Thanks for your answers

---

Welcomely in the forum!

In principle it is meaningful to already separate the lines with the call numbers.
Therefore would advisable possibly be it. to de-energise themselves and furnish a further VoiP number with 1&1. (up to 4 call numbers are possible)
A further Konfig. would be then no longer necessary.

In this connection the question arises however nevertheless, has you a 1&1 DSL R- Tariff with analog line (then you would have only 1 call number) or do you have a 1&1 complete connection with so far only 2 VoiP call numbers?

---

Rear one, I have only two similar lines with DSL6000. Would like also only 2! It must have a reason, normally why I can be called by a mobile phone and by a T-COM-connection (have I just tested), and if one calls from a VOIP connection goes after 2 seconds. the fax ran. One hears straight still: “Hello, here is…” - that cannot be probably…

---

Hello,

you must adjust the MFC in the box as pure fax equipment and activate “Busy on Busy”!

---

Have it examines FAX EQUIPMENT again is in the FRITZ BOX 7113 selected “busy on busy” I times set - does not help also. Have times on 5x ring increased - no difference. The fax stop goes ringing after the 5ten times ran. (Practically one strangles OFF)

Case 1: if one goes to the arriving discussion ran, the FAX squeezes itself immediately between them and beeps to the caller the ears fully

Case 2: If one lets the STARTING FROM go ran, it rings like said 5x and then in the same moment as the STARTING FROM starts also the FAX starts and beeps.

-> Calls over a VOIP No. further not possibly (TCOM and Mobil still function)

Who can help o. Tipps (firmware the Fritz has! Box 7113 is the current 60.04.57)

---

it did not help all anything (also type from 1und1 a new number in Web-front-end to generate and registrerieren.)

The solution was: Do not configure the MFC 885CW as fax and also not as telephone, separate as!!! As answering sets in the Fritz! Box functioned everything. So a Sch….

Thanks everything for your Tipps

Greeting
Shrinky

---

identical problem today with a SHARP UX-A460. As fax configured the calls were not externally at all accepted of. Solution also here in the Fritz! Box as OFF configures and goes.

---

and again verified with bread ago fax 1030e now as OFF configures

... functioned likewise.

I ASK YOURSELF ONLY: Why neither the Borther nor the SHARP knows still the 1und1 still the AVM Hotline.