Complete connection hardware - VoIP General, VoIP News, VoIP Providers, VoIP hardware, VoIP software, VoIP Technology

1&1 writes me, a technical examination has devoted that the removal is not possible on the complete connection with the hardware attached at present, I am a Surf&Phone box (FRITZ! Box) order.

I have however FRITZ! Box 5050, which I can change over entprechend.

, E.g. replace Voip data check off fixed net again purely, fragments/TelKabel. by a modem cable (or leave also simple) and finished.

Are my considerations correct, I which forgot,…?

Hello Franz,

which means 1&1 hereby, the possibility is supposed of establishing for the Telefonie over DSL its own tunnel (PVC = permanently Virtual Circuit) you a substantially higher quality and availability for the Telefonie ensured. As it were the IP packages for the Telefonie and the data become, e.g. Internet, in different channels up to the DSLAM and to the gateway from 1&1 continue to transfer. This is supported, as far as admits to me, only by the 7050, 7170 and the 7270. The SLA sealed contractually by 1&1 with you determines as minimum requirement for complete, so that resistance against it is probably useless (those have then the Trouble because of the disturbances and to try thereby to prevent). Thus look whether you somewhere suitable Fritz! Box for appropriately money gets and accepts this.

Cordial greetings

Quotation:

Quotation of Gabriel

This is supported, as far as admits to me, only by the 7050, 7170 and the 7270.

No. There is the Fritz boxes 5140, 7113, 7141, 7170 and 7270.

with the 7050 I know the attitude nevertheless for the Telefonie also

further connection for the Internettelefonie over DSL use (PVC)

click.

Why doesn't belong you into the list? Or is which other one meant?

Is there hair dryer, in which there is not the switch?

Hello Franz,

“further connection for the Internettelefonie over DSL (PVC)” are made possible exactly the attitude, those use the second channel and the 7050 can I that times also, there already configured. Otherwise the list of rosx1 can be quite applicable, there is missing to me then the overview.

I have degrees times ne old Fritz box hair dryer attached (debranded) gives it even there this attitude (FW6.4.33).
With that version (AOL) does not debrandet gives it the attitude not, although AOL used that always already in such a way.

Unfortunately does not succeed debranden me for the moment the AOL box. /proc/avalanche/env does not find the path. But belongs probably elsewhere. But a tip would be also welcome.

the attitude does not have my 7113 of 1&1 also (surf&phone completely 16mb)

you must switch on also the expert mode

already clearly - is however non custom it in addition, not

Demand with 1und1: it concerns the starting code, which the “old” boxes do not make. (and the data for PVC - login one can not communicate to me). Without that it is not to fold with the emergency call.

Believes it goes also around the point “automatic mechanism by the service tenderer permitting”. I got no starting code, which I must register.

one can check the starting code nevertheless in the control center 1und1 Kundenlogin.