I have now finally VoIP and try now, me a halfway comfortable cord detachment out hedges. I am encountered the following problem:
I have the Headset connected with the computer (Bluetooth audio) and can over it Winamp hear or also telephone, how I want. As soon as however my Sondkarte is used, I hear nothing more.
Speak: I telephone, someone write to me a ICQ message, my loudspeaker boxes make “o-oh” (typical icq sound stop) and I hear humans, with whom I did not telephone to no more. If I the program start (IP-Fonie or also only winamp) go it again again. The Bluetooth connection tears thus not off, my interlocutor hears me also further.
That is with 2 tested Headsets like that (Motorola HS801 and Logitech). I could not change Dongle yet, am a EPoX BT-DG02 with WIDCOMM driver (both version 1.4.2.10 and 1.4.3.4 tested) on the ASUS A7N8X-E Deluxe with the NVIDIA NForce2-chip (driver version 6.14.0362.0 (3.62)).
Did someone hear a similar error or already times of it? Or can help itself with proposals for solution?
Thanks,
DerYo-->
Hello deryo,
plan likewise to add me in foreseeable time a Bluetooth Headset. Could you communicate times exactly, you have which models and how you are content in each case with them? Would I have me except the EPoX BT-DG02 (functions with both?) still which add?
TO YOUR PROBLEM: I read somewhere times that one should adjust the sound map as kind-moderate output device in the Windows system control. Then at your VoIP software as in and output device again the Headset select. Reports times….
Nice greeting,
Qarsten.
Hello Qarsten.
Was already exact:) Motorola HS801, of Logitech gives to ' only one (Logitech mobile Bluetooth Headset) s and Dongle I already wrote.
Otherwise one does not have to add oneself anything
To my problem:
That made exactly the same, how you described. (I had eh…) No effect… However it noticed to me now that it functions after some seconds again. The Logitech has now by the way again, first had errors during the speech transmission.
Since I think that it is a driver problem, I bought now a new Dongle, in hope that it uses another. It is the D-left DBT-120. I habs however not even attached, because it uses also the Widcomm driver.
Are there at all Bluetooth Dongles, which do not use the Widcomm driver? Fritz perhaps?
Are grateful for each assistance.
If I had time to attach the other Dongle write I again whether somewhat changed.
DerYo-->
Edit:
Still three unpleasant things were noticeable to me.
1. That Logitech headset goes only into the Standby enterprise, if it is not connected with the computer. Thus only 7h period of operation. (instead of 300!)
2. If one separates and again connects it however if a call is received (folds!), the standard output device is set automatically on “bluetooth audio” (probably of the Widcomm driver). All the same which I make. Nervt!
2. The Headset does not seem to go also with my telephone (Nokia 6310i, Nokia 6230) into the Standby (anyhow the LED indicates). Motorola made from alone!
Unfortunately I do not have Motorola for testing for order. Since I had yesterday already again language problems with the Logitech (all the same at which equipment it angeschossen was), I to supposed also still write shortly will be able, how the 99-euro-teil of sony erricson behaves…
Hello,
no solution for the problem does not have, but has this problem.
Use Widcomm 1.3.2.7 with a hama BT Dongle and a 08/15 BT-Headset (HTC-0221).
I can, during I e.g. Music with Winamp over the sound map (Nightingale pro 6,5,1) hears to telephone, without problems with the Headset.
Preferential audio device in the system control is the sound map. In the X-Lite and Skype I adjusted BT-audio as audio device.
ok is with me for a long time ago, but I did not have problems with mine logitech bt headset ever. standby folds however only, if you terminate communication with headset, that is with handy also like that, only it makes that there automatically.
the “error” /feature (like one it to call likes) that that comes to standard output with to connect on bluetooth audio changes is me already nerve-ends been noticeable. I am me surely that I that times weggeconfed have. however I do not know absolutely any longer how.
you should times a new widcomm software add, 1.3.x are in all other respects betagt already relatively. I had at that time believe 1.4.x and that am already months ago.
achja there are still sticks, which have one as software named “bluesoleil”. kA from where comes and with which devices thereby is.
hope you can which with the information begin.
bye
Quotation:
Quotation of deryo
Are there at all Bluetooth Dongles, which do not use the Widcomm driver? Fritz perhaps?
(...)
If I had time to attach the other Dongle write I again whether somewhat changed.
|
Hallochen,
may I ask times, what understands it by a DONGLE? Is that the small USB Bluetooth stick, which I put simply into the computer?
And if, how I find out whether this Dongle (which I have then already) supports a Widcomm driver?
Thanks already times. I must equip (notion of nix) to tomorrow (Christmas) ne friend with IP-Telefonie and Bluetooth Headset, and which should even also still function whole then… <Compassion…>
Greeting carrot
a dongle is a usb bt stick
and here
http://www.jonsguides.com/bluetooth/ ' s gives a guidance, how one runs a more current widcom version on sticks without current version to gets and naturally a compatibility-listed.
glad Christmas
Hello,
my experiences were that one could telephone with the Bluetooth Headset cleanly. I used a Delock usb bt stick. The Headset was only lent, therefore I cannot call the name here any longer.
Only which I felt disturbing was that one could not accept a discussion directly at the Headset. The discussion could be accepted only by software (IP Communicator of CISCO).
The actual acceptance key at the Headset activated or deactivated only the Bluetooth connection.
Does someone know this problem?
Where could this problem lie (usb bt stick with driver, Bluetooth Headset or IP software)?
I search at present its own Headset. Here does someone have a recommendation?
Thank you
Hello,
I use the following configuration:
Laptop Fujitsu Siemens Amilo D 1840 - and - Desktop PC
Logitech mobile BT pro 1.2
AVM Bluetooth 2.0
Skype
So far I use this configuration as test I after a slack solution with DSL Telefonie Skype search there.
With me the following problems arise with telephone with Skype:
Opposite participant can rush me only very badly with and also chopped off understand. I understand to rush the participant well however have I also now and then in the ear a which am however bearable nerve-end only in the long run to be can.
Uses possibly. also someone this configuration??? and report itself as good or bad can this is?
Perhaps someone has one taps like this to rush with opposite participant to be repaired can possibly. an update for the devices or other attitudes. Are for everyone tap gratefully, since I spent meanwhile already high amounts on hardware.
Quotation:
|
Perhaps someone has one taps like this to rush with opposite participant to be repaired can possibly. an update for the devices or other attitudes.
|
Rear one,
The customer service of Logitech states that the Headset Logitech mobile BT pro is not suitable for communication at the PC. I have the same problem with the strong noise. Use the Dongle of diNovo Media Desktop.
Here already did someone try the Headset out CS60 USB von Plantronics? - This strikes 299.00 in the standard price of EUR violently to beech, but it has a professional manufacturer of Headsets in the background apart from the range of a DECT telephone. - Over empiric reports in addition I would be pleased.
Rear one.
The statement of the Logitech of customer service shocks me now however. On the Website mobile pro stands explicitly that it can be used with the PC, only therefore has I it for me the day before yesterday bought…
Quotation:
|
The Headset can be used beyond that with Bluetooth compatible PC.
|
Naja, with which mobile phone functions the thing also perfectly, however has I with the PC not yet in such a way gets.
I use a Acer Notebook with Bluetooth, thus that I do not need Dongle, see nevertheless correct do I think, or?
It is also possible for me to connect the Headset with the Notebook however it does not continue then. In the sound attitudes I can select nevertheless nothing else as the sound map etc. Speak: it is attached, cannot not be used however.
I which wrong made? Where could the problem lie?
Would be very pleased over assistance!
chris
the question is which software with your Acer Notebook is installed, Microsoft BT software used, then no Headset profile is available, speaks BT Headsets can is not used. Property by the way also the Lgitech BT Headset, functions perfectly with the PC. My BT software is however from WidComm.
Achso. Then I assume times from Microsoft is.
1. Can I install the Widcomm software simply? You have nen there left, I would know not which… Or isn't that possible?
2. In the case I would have to buy a Dongle, then the software is thereby…? Only if I really need a Dongle, which hold you from that here:
AVM BlueFRITZ! USB v 2,0 Bluetooth USB stick If own software, not, uses Widcomm however only positively one tested… What says it?
I have only times this Info.wie one from Microsoft BT software too widcomm change
http://www.e-beam.com/support/Switch...to_WIDCOMM.pdf
and look also times here
http://www.wintotal-forum.de/index.p...c,68057.0.html
The Widcomm driver of the acer software installed. Now funktionierts perfectly… Thank-beautifully