02 2602hwn D7A as ACCESS Pont - VoIP General, VoIP News, VoIP Providers, VoIP hardware, VoIP software, VoIP Technology

Rear one,
I possess gennanten the above rout from my old CO2 contract and have now cable German Federal Armed Forces. Will gladly wisssen whether it is possible these as ACCESS POINT to use my rout more again there no W-Lan has. Unfortunately I cannot in the original CO2 menu rout this to ACCESS POINT to change over. Ghet with telnet if how?

Thanks already times in vorraus

Normally hands from if CO2-rout with existing rout via LAN is connected, LAN must be furnished, the IP address may be firm. In the WLAN menu the coding is to be indicated and SSID. Then everything should run nevertheless

for 1 Client it would have to go, but it in the mode the WLAN only a IP assigned assume I. Change alternatively the DSL entrance over. There Ethernet would have to be also available - if necessary by telnet.

how do I make exact by telnet?
in the menu everything is sgesperrt there CO2 firmware

Quotation:

Quotation of ilvoip

for 1 Client it would have to go, but it in the mode the WLAN only a IP assigned assume I.

on cable-rout must a DHCP server be furnished and the network mask is IP address of the UFO to cover. Administers all Clients, Ethernet and WLAN.Ansonsten must on each WLAN client the IP address be assigned manually. But belonged here purely, I do not think the topic times, since it is general network mechanism. For the UFO Einrichntung necessarily does not become telnet as well as a AP-mode.

Goes also without DHCP servers?
Can't I rout to ACCESS POINT to somehow change over thereby I at the cable/modem rumwerkeln must?

Pa-jt actually the standard of routing described. Whether with cable also like that is… no notion. You must adjust the AP/Router to a suitable IP, all attitudes for WLAN etc. make, then DHCP out and finished.

Quotation:

Quotation of Igel12

Goes also without DHCP servers?
Can't I rout to ACCESS POINT to somehow change over thereby I at the cable/modem rumwerkeln must?

Does that have cable modem a firm IP address also admits is?

as far I white does not get one with kabelbw a firm IP however I white as I there rankomm

it is completely all the same which IP you in the cable system has - you must put on only your own net and in addition need you the address in yours cable-rout (from the LAN side), the DHCP server, its ranges etc. and then you can CO2-rout addresses to assign.
Do you come to rout somehow to? Web surface? Try times ipconfig /all and enter afterwards the address standard gateway in the Browser.

it is indicated the following:
Ipv4-Adresse 95.208.113.137 prefers
and
DHCP server 172.30.34.10

That is not routs, only a cable modem.

Best the UFO in Bridge mode would be to be set, I hab's however does not get.

I and I do not mean exact can let us CO2-rout because of the CO2 firmware into the Bridge mode to switch, have however somewhere read it with telnet go are and wanted to know whether jemnad here white how

http://www.ip-phone-forum.de/showthread.php?t=130908