CO2 Telefonie on Fritz box 7270 - VoIP General, VoIP News, VoIP Providers, VoIP hardware, VoIP software, VoIP Technology

Hello Leutz,
I estimate it have the topic slowly through however I need times your assistance!
I am am that 19.01.2010 with CO2 (was before with Arcor) me before my change after CO2 the Fritzbox7270 GEC up and under arcor run let, heist the those am free from possibly a DSL offerer garbage (Branding), which at the same time represents also my problem I wanted CO2 over the Fritz box run to let with the Internet has I gets only with the Internettelefonie goes possibly as net. know their me nen left or ne 1zu1 guidance to give which I where adjust must thereby it folds has also at this left http://www.ip-phone-forum.de/showthread.php?t=129819 held which is described there funz so however net.

Thank you for your assistance

Hello,

three counter questions:

1.) why didn't you gepostet within the forum range, where your quoted guidance stood?
2.) why you have this guidance doesn't use?
3.) why don't you use (to some extent) the correct orthography (upper and lower case printing capability, comma and points, paragraphs)?

HP: Welcomely in Forum (none Chatroom).

EDIT: Worth Mod's, I thanks!

“net funz so however.”

Then should be mentioned however please which does not go exactly and which error messages in the log to appear. I bet, it is one of the options in the Fritz box, which was not set correctly after guidance.

@Abuze, look nevertheless times, which guidance it used… :

I had times forwards approx. the guidance to two attached down years provides. Here the steps are described, it kept its VoIP data presupposed for the mechanism of the 7270. The guidance is however written for use second PVC for VoIP.

Possibly. it helps; =)

Hello Leutz,
Sorry Doc for my way of writing.
Thus the Fritz box spits the following error message into results from a cause 401, hopes it helps you.
Saber: after the guidance I proceeded point by point. But that unfortunately does not fold. It does not register simply the telephone numbers. I got the course to data for Internet and Telefonie from CO2.
Internet: o2@dsl.o2online.de pw: freeway
Telefonie: RETCSxxxxxx pw xxxxxxxx
that is the VoIP data of that talks here is????.

Quotation:

Quotation of doc456

@Abuze, look nevertheless times, which guidance it used… :

OMG, explains some. It gives nevertheless a Wiki:
http://wiki.ip-phone-forum.de/gatewa...ods:eek:2dsl?s[] =o2dsl&s [] =fritzbox

@maxe2212:
That that is a part of the data and attitudes. However all attitudes (see Wiki) must tune!

Quotation:

Quotation of maxe2212

Telefonie: RETCSxxxxxx pw xxxxxxxx
that is the VoIP data of that talks here is????.

Those are the VoIP data, pay attention please to the large/lower case with the password.
The Sipcode 401 means: , Therefore you will have wrongly registered warscheinlich the entrance data for the Telefonie to Unauthorized.

Moin,

da ihr (Abuze/saber2003) ja schon alles gesagt habt (saber, die Anleitung ist supi!), sitzt der Fehler 401 imho vor dem Bildschirm...

Hello, I tried it now at least 6 times!!!!!
Unfortunately always the same result error 401
Thus did I call with CO2 and my login data compared however to tune which now?????

What now? Well completely simply: back on beginning = Recover , POR for min. 5 minutes and re-entry of the entrance data!

Upper and lower case printing capability possibly. considers? (I have no CO2) only that would possibly be. a starting point

//Nachtrag: here are div. further information: http://www.ip-phone-forum.de/showthread.php?t=129819

Hello Leutz,
has it get had ne number too much in the user name and I had my Internet connection of o2@dsl.o2online.de up o2@voice.o2online.de change over.
Thank you for the assistance

What A surprise!

Then fast still set the Thread on [settles]. How? 1. Post office/a changing/extended/titles down fill…

Quotation:

Quotation of maxe2212

... and I had my Internet connection of o2@dsl.o2online.de up o2@voice.o2online.de change over.

If I cannot believe somehow in such a way and if should fold, then is there nevertheless which not ok. Try it once again:

UserID DSL: o2@dsl.o2online.de
Password DSL: freeway

Rumschrauben voip.cfg and ar7.cfg is no longer necessary with the 80's L.G. on. As soon as CO2 is registered a SIP number the haven to 50000+32 is automatically adjusted. The DSL account data are also not more necessary now, since one can select CO2 directly. Only if additionally other VOIP accounts should be used except those by CO2, one still the attitude for the 2 must. Change PVC (VPI 1/VCI 32, PPPoA/VC Mux or PPPOE under Internettelefonie -> Extended attitudes eingtragen). That's it.

Before the attitude I would recommend, if necessary. to change over the Branding to AVM and to put the box back to factory settings.