CO2 UFO (Zyxel prestige 660HW) at Hipath 3000

Nextiva is a cloud based VoIP phone system, hosting lots of small and medium sized businesses nationwide. the provides UNLIMITED business calling for only $19.95 a month!! Click here for the detail about this promotion!!

Hello,

toward more than one week experimenting and hair to peel off I can contact now only you.

I installed a box (Zyxel prestige 660HW) for CO2 at a customer according to its desire. This box supplies surprisingly also a then. I at least thought.

This so is to be attached to the Hipath as office connection. Before the CO2 box a conventional NTBA at the customer (one of many) was. With this everything ran marvelously. If I close the office cable of the Hipath now at the then of the CO2 box, the line keys remain on. (shine thus red, signaled that no signal to the STLS4 arrives) in such a way slopes I the cable one (others) again everything runs.

Now I thought the CO2 box am defective. Thus took I mean listeners and tested the thing. A signal came on, calls clean and raus. Everything chic. *grbel*

Thus I also still the interwirings examined, cables exchanged, plugs again pressed - it did not help all anything. The plant has still a dislike against the CO2 box.

Much times still, the POSSIBLY no supply voltage by the CO2 box one supplies with to me sometime. Thus I called in the TBO with CO2 and inquired there times. That is to be like that.

Now my question….

Can I with the Hipath sowas like a “phantom powering) on the then drunkenness configure OR the CO2 box to it arrange a tension on the then to provide?


Best greetings
tomquenten

---

Rear one,

how is with the Highpath of the S0 configures?

Multi-equipment or plant connection.

Greetings

---

Oh, the most important forget….

The mentioned like that is in the plant as PMP configures.


Greeting
tomquenten

---

no an idea?

did nobody have the problem already times, all the same whether with zyxel or the boxes of alice?

I would be extremely grateful for an idea.


tomquenten

---

The S0 at the “UFO” of CO2 is not ISDN compatible straight. Therefore there is for it also no support. If it actually CO2-rout is, the O2-Subforum would be the better place for CO2 routing problems. I know actually only the 2602-Router von O2. 660HW -???? strangely!