UFO and Bridge/WAN - VoIP General, VoIP News, VoIP Providers, VoIP hardware, VoIP software, VoIP Technology

Hello,

I have CO2 DSL since the 30.09.08.
Before it I had the UFO test way at NetCologne, I had to tighten, the thing am not the Bringer.

Up to the conversion to CO2 there was also the menu option “WAN” however now is it somehow away (since when I do not know exactly).

There there was at that time also the “Bridge” option.
How do I get the WAN menu option back?

Stefan

since the letzen L.G. update disappeared the menu.

per beer times hiemit!

http://IPdeinesRouters/WAN_Adv.html

Quotation:

Quotation of saber2003

since the letzen L.G. update disappeared the menu.

per beer times hiemit!

http://IPdeinesRouters/WAN_Adv.html

With http://IPdeinesRouters/WAN.html one comes to the Bridge.
So then I can test today.

Are correct the entrance data:
user: o2@dsl.o2online.de
passport: freeway

Stefan

Thanks for tap, the attitude for the Bridge I also looked for.

This attitude is sufficient, around 2. Rout then for Internet to operate?
And/or for the VOIP von O2, because that is further over the CO2 box to run.

Thanks for information

SD-6

Somehow I cannot store the attitudes. Does ' s give ne other possibility?

Quotation:

Quotation of SD-6

This attitude is sufficient, around 2. Rout then for Internet to operate?

As you want the 2. Rout tie up? Passport through and multiple registration does not go with CO2!

Thus get I habs.

By telnet I the attitudes made and can now at the Linksys WRT54GL by PPPOE in-select itself. All super folds. VOIP runs further over the CO2 routs. It pay attention that sip.o2online.de does not do any longer because of missing DNS. There the IP register and are good. Internet runs now completely over the Linksys. That CO2 rout is momentarily as Bridge furnished!

Greeting SD-6

Rear one,
SD-6: Do you have the CO2 route thus before the Linksys?
If, which I must adjust everything with telnet?
How the Bridge mode?
How do I enter the DNS directly?

Greeting Testman1

Rear one,

has the Linksys directly behind the CO2 rout.

I changed the following attitudes by telnet:

wan node index 1
wan node enable
wan node bridge on
wan node routeip off
wan node nat none
wan node encap 1483
wan node save
sys save (with it it has routs then rebootet)

Now I would test first times whether the Linksys can in-select itself. If you must change only the SIP over address to IP.

In addition I in the forum folgendendes found here:

http://192.168.1.1/wzVoIP_1.html

so I could register the IP address instead of sip.o2online.de. Changes may not do they stop

I hope I could help.

Greeting SD-6

http://www.ip-phone-forum.de/showthread.php?t=183227

Which IP do I have to register in place of sip.o2online.de?
How do I find those out?

These IP can indicate: 62.53.234.84

Greeting SD-6

Moin together

Even if that now already longer back lies must I times stupidly ask.

Thus I have the CO2 DSL rout Classic with the firmware V3.40 (AOF.6) D0 | 09.10.2009.
To me goes heavily on the lacing which I with my Xbox360 only causes on-line ones zocken can. That is since which I the firmware drauf has.

Which I want am part to used like SD-6 described in such a way now. Only if I in such a way proceed go nix more except which I SIP have.

On the WRT54GL have I dd WRT v23 SP2 (09/15/06) std (SVN revision 3932). And I get myself it not the crate in-selected.

I receive here still another vest… explain me nevertheless times for a Blden which I with the Linksys to adjust must and which with the O - muck cattle?!?

Or differently… I can switch Firewall and NAT off completely?!?

Alex

rear,

thus on the CO2 rout then only sip goes is to nevertheless ok, that is to be also like that.

Did you adjust your Linksys then also to PPPoE? That must vornhemen the a choice.

I changed meanwhile back to the Telekom, have my Linksys to to run and am lucky

Greeting SD-6

Rear one

I have the Linksys also so adjusted which it to in-select itself is. As the suitable indicated… thus user: o2@dsl.o2online.de password: freeway. Also on PPPoE however at the CO2 equipment it shows only to the telephone is however no Internet.Ich there gets simply no connection and has thus also no valid IP.

Thus I am nearly so far the muck thing in hit a corner to schmeissen and my old Speedtouch to to pack. Then have I none festnetz more however I can again normally Internet use and can finally again on-line zocken. The new firmware is the latter….

Tja Telekomik….those do not have it 5 years business their contract to fulfill….Never again T… those are the opinion with me go only to ISDN and with much luck DSL Light… I hang times Orb spades to….

But me it became already hands if I the Firewall and NAT in the O - thing to switch off could…

Alex

Quotation:

Quotation of AlexB

I have the Linksys also so adjusted which it to in-select itself is. As the suitable indicated… thus user: o2@dsl.o2online.de password: freeway. Also on PPPoE however at the CO2 equipment it shows only to the telephone is however no Internet.Ich there gets simply no connection and has thus also no valid IP.

The UFO also only indicates, which has it a Sync.
From where it is to also know, which the other one rout a pppoe connection has.
And how is the UFO to get the IP of the Linksys?

Stefan

Quotation AlexB “CO2 DSL rout Classic” no UFO!!
This thing shows very much very on whether it Internet and/or connection has. Look times on Bild.Und the IP gets it from O … thought I in such a way.

I say, this hermaphrodite mode functioned not so really…

Alex

Quotation:

Quotation of AlexB

Thus all the same whether UFO or the other one.
You have two lines, one for VoIP and one for DSL.
If I see that correct, you want it like I here.
Thus VoIP in the CO2 rout and DSL with another.

If like that is, white that CO2 do not rout, which exists Internet a connection. it does not develop it. I can make if necessary gladly pictures.

Stefan

Mhmm.

Already. But it is usually so the one modem (egla which now) the connection indicates although routs selects. Was to mindesten with me and the Speedtouch in connection with the Linksys like that. Therefore I am assumed that this CO2 cattle also make if it now then am so adjusted.

I have now with these… I call it times “Hidden” sides still of the actual Zyxelfirm in it are tried now. The problem thereby is which it to strains does not store and/or does not implement. The firmware is thus more or less the same as in the UFO.

But again from the front with it clearly is which I wants.
VOIP should over the O hires to run wenns goes. The Linksys is to take over the remainder.

The Linksys is thus to in-select and everything which with WAN to do has to take over. With it I mean also Firewall and NAT.Denn since the V3.40 (AOF.6) D0 now am different things which I at the PC to make want and with the Xbox360 on-line zocken no longer possible.

I can switch off over the WEBIF of the O - cattle the Firewall….That is however unfortunately not really the case. Some haven are simply not open. And the NAT test to the Xbox is knits.

I thus by telnet in the O - the cattle adjusted. Linksys configures again. There Voip was and wars. In the Linksys on Connect geklick. Nix.Keine connection.

You see on the basis my novel (sorry for it) which I get here the moths.

Alex

does the question arise naturally whether those are telnet of instructions the same, and whether it goes with clasic at all? Thus whether it can be shifted in the Bridge mode??

And like already written, the connection does not have to be indicated obligatorily, because the a choice of the Linksys makes. Was with me with the “UFO” also like that. Only VOIP, and/or. the DSL Sync. shone.

Moin

He was not safe of Naja, according to WEBIF thereafter in the Bridgemode.Nur is I me there.
Alex