faxes over the Fritz box 7270 - VoIP General, VoIP News, VoIP Providers, VoIP hardware, VoIP software, VoIP Technology

Straight ones I wanted which to the tax office faxes, only it do not go through not. All the same which I make, it is always occupied. From another fax it funzt.
Can it be that CO2 has problems with faxes? To other numbers it does not go also.

Your information is even for ours Glass balls too meagerly ......

Which have you exactly tried, which attitudes have you transacted, etc., etc., etc. .......

Well I put the fax on the fax and selected the number

In the Fritz box the outgoing number is furnished as fax. Receiving folds problem-free.

Merrily, honestly

But if you expect to reach with such information something liegts you wrongly.

I infer then from your extremely detailed remarks that you operate external fax equipment at the Fritz box and not Fritz! Fax uses. Did you switch on or off in the Fritz box times T38?

Obviously I use an external fax. A Epson CX-11NF multi-function printer with fax.
Sorry, I did not have at all to the Fritz! fax variant meant.
What is T38?

T38 is a special standard frs faxes. Faxt you by VoIP?

see appendix

Standard advice for fax: It down-places and examines speed whether the equipment has at all free characters.

I am with 02, there give it only to Voip. It went however already times. Where do I place the speed down? Directly at the fax or in the Fritz! Box?

That can be done only at the fax equipment.

Did you try times whether the fax receives a free character?

T38 examines in the box?

T38 is thus good in. I have it times issued and there come now the same result. Do not speak it goes.

Which breaks in also straight. When it functioned, I had still the UFO box in the employment. Ergo would have to be it because of the Fritz box.

Quotation:

Quotation of zefix

... it is always occupied.

is the plug in it? Switch on the fax nevertheless the attitude on of modem control, thus telephone noises up to the connection establishment. If there is already a busy signal with beginning of fax, the call does not go at all raus.
Fax equipment to 9600 Baud set

So now I exchanged the cable and to the fax a firmware update gave. And now it folds again,….

And already it does not go again any longer.
Structure is the same as before also.
Still ne idea, which I can still make? I have unfortunately no notion, as I place the Baud rate downward with the CX11NF.